Fan-fold pleater details

When I posted earlier about the Tale of Two Uglies, I showed a picture of green fabric in a pleater that I use. A couple people have asked me how I made it, so here are some pictures.
The first picture shows an over-all view with a yardstick for scale.OLYMPUS DIGITAL CAMERA         The second picture shows a closer look at the back side.OLYMPUS DIGITAL CAMERA         Here’s a close-up of the front. The red line is the center from end to end, the lighter blue lines are on either side of the center slot. That helps me start my fabric in the middle of the pleater if I choose, and, if I want to help keep it square, I can put a crease down the center of the fabric and try to keep it in line with the red mark as I pleat.OLYMPUS DIGITAL CAMERA         The last picture shows an end view with the slats spread open.OLYMPUS DIGITAL CAMERA         The wood I used was actually dollhouse siding, and hubby donated it because he was never likely to use it for anything. Any wood, including light (1/4”) plywood would work fine. You’d need to sand it well to smooth it. If you used plywood, it could be cut from a 4’ width of material.
The fabric I used for the back was canvas or a heavy denim. Again, it was what I had laying around, and it was old and 36” wide. I then glued and stapled it to the slats. The staples are in the bottom of the face of the board, rather than trying to staple into the skinny edge. The glue I used was probably Elmer’s, and I would change that to a silicone or rubbery adhesive. White glue dries too stiff.
When I use it, I push the fabric down into the slots with a plastic drywall spatula. A credit card or other flat squeegee tool would work.
PS – please help my with my business wish by voting at http://bit.ly/15nmMG8 . Totally anonymous, and it will helps towards a chance for me to go to the Houston shows in the fall. That trip will be so expensive that I doubt I could make enough money to break even.
PPS – if you haven’t, and want to, please sign up for the DippyDyes mailing list.

3 thoughts on “Fan-fold pleater details”

Leave a Comment

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.